![]() When you release the pedal, the ECM erases the trouble code(s). Note: You can clear the code (and the annoying MIL) by holding down the accelerator pedal for more than 10 seconds while in Diagnostic Test Mode II. In the ESM, refer to page EC-639.Īdditionally, if you get four blinks of ten (0000), the ECM is indicating no malfunction. The P0600 code is a diagnostic trouble code that points to a malfunction in the communication link of the ECU. You can look up the trouble codes in the ESM/FSM there’s a bunch of them. The ECM code repeats its self until you turn the ignition key to the OFF position, at which point the ECM resets itself to standard get-in-and-drive-the-car mode. The next three digits follow in turn in the same fashion except with faster blinks (0.3 second) and a 1.0-second pause between digits. Long flashes (0.6 seconds) indicate the first digit of the code count the blinks one through nine and write down the first digit. Fully depress the accelerator pedal for ten seconds (15 on GT-R) or until the MIL (SES) light flashes.ĥ) Release the accelerator pedal and start counting flashes to obtain the four-digit trouble code. (Do not start the car.)ģ) Fully depress and release the accelerator pedal five times in less than five seconds.Ĥ) Wait exactly seven seconds. In car ECM Diagnostics/ECM Reset procedure:Ģ) Turn the ignition key to the ON position and wait three seconds.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |